Advertisement
trol works at from 150 to 1.5kHz.
PRESENCE (8) This is a special active tone control that boosts extreme high frequencies by as much as 15dBV.
POST EQ EFFECTS LOOP (9) This is a standard mono post EQ effects loop, remote selectable (via MIDI or
supplied hand controller), used for patching effects into the signal chain. High quality shielded instrument cables
should be used from the SEND and to the RETURN in all cases.
SPRING REVERB (10) This control adjusts the level of the more familiar "spring" reverb found on older ampli-
fiers, separate from the digital effects section and is remote selectable (via MIDI or supplied hand controller).
DIGITAL EFFECTS SECTION (11) This section contains separate adjustments for the digital chorus, delay,
and plate reverb and is remote selectable (via MIDI or supplied hand controller) in the form of a universal
effects defeat. The settings are saved after the amp is turned off/on and so this, essentially, acts as a multi-effects
unit would in a normal loop. The ADJUST control alters the parameter that is selected by the SELECT control.
Pressing the SELECT control bypasses all digital effects and pressing the ADJUST control sets the TAP TEMPO
of the digital delay.
NOTE: When both speaker jacks are used, the SPRING REVERB, DIGITAL EFFECTS SECTION, STEREO EF-
FECTS LOOP, and MSDI are automatically split into stereo operation. When only the LEFT/MONO SPEAKER
is connected, these are all summed to a mono signal, in the same manner.
MASTER (12) This controls the overall volume level of the amplifier.
POWER (13) This switch applies AC power to the unit.
REAR PANEL
16
LEFT/MONO (MAIN SPKR)
250W RMS
4 OHMS MIN
CLASS 2 WIRING
31.7V RMS
SPEAKER OUTPUTS
GRND
L / M
LIFT
MSDI
TM
15
RIGHT (AUX SPKR)
EFFECTS LOOP
RETURN
250W RMS
4 OHMS MIN
31.7V RMS
RETURN
GRND
R
LIFT
MSDI
TM
FUSE
14
STEREO
FOOTSWITCH
(MIDI IN)
SEND
L/
MONO
SEND
R
17
18
A PRODUCT OF
PEAVEY ELECTRONICS CORP.
13
Advertisement
