Table of Contents
Advertisement
ENGLISH
Fig. 6a
1
1
Fig. 6b
Stationary use
Flat washer
Miter saw base
Work surface
Flat washer
Hex/Lock nut
For portable use (Fig. 6a, 6c):
•
Place the saw on a 3/4" (19 mm) thick piece of
plywood (Fig. 6c). Bolt the base of the miter saw
2
securely to the plywood using the mounting holes
(Fig. 6a) on the base. Use C-clamps (not included) to
clamp this mounting board to a stable work surface
at the worksite. (Fig. 6c)
Fig. 6c
Portable use
2
10
1
1
Hex bolt
Rubber washer
Lock washer
Jam nut
1
WARNING: Carefully check the workbench or stand
after mounting to make sure that no movement can
occur during use. If any tipping, sliding, or walking is
noted, secure the workbench or stand to the oor
before operating.
Adjusting leveling foot (Fig. 7)
NOTICE: For stabilizing the tool the height of leveling foot
can be adjusted.
Turn the leveling foot clockwise or counterclockwise
1
depending on the amount of support needed for making
sliding cuts.
NOTICE: Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional so
that we can clearly show points being made in the
illustrations. Never operate the saw without all guards
securely in place and in good operating condition.
Fig. 7
1
Install the workpiece clamp (Fig. 8)
NOTICE: There are two mounting holes for the workpiece
clamp. These are located just behind the miter fence on the left
and right side of the base.
The workpiece clamp provides greater control by clamping
the workpiece to the miter table. It also helps to prevent the
workpiece from creeping toward the saw blade. This is very
helpful when cutting compound miters. Depending on the
cutting operation and the size of the workpiece, it may be
necessary to use a C-clamp (not included) instead of the
workpiece clamp to secure the workpiece prior to making
the cut. The workpiece clamp can be installed and used on
either side of the blade.
To install the workpiece clamp:
•
Place the workpiece clamp shaft in one of the holes
located behind the miter fence.
•
Rotate the workpiece clamp knob to move it up or
down as needed to secure the workpiece.
1
1
2
3
Hide quick links:
Advertisement
Table of Contents
