Press and release the TEMP button to view HI/LO, temperature and humidity readings with
time/date stamp. Press and release TEMP again to view the next value.
• Outdoor temperature HIGH
• Outdoor temperature LOW
• Outdoor humidity HIGH
• Outdoor humidity LOW
• Indoor temperature HIGH
• Indoor temperature LOW
• Indoor humidity HIGH
• Indoor humidity LOW
• Feels like HIGH
• Feels like LOW
• Dew Point
Note: Dew Point Temperature is not time/date stamped.
RESET HI | LO TEMPERATURE/HUMIDITY RECORDS
Press and release the TEMP button to view individual HI | LO readings.
Hold the MINUS button for five seconds to reset each individual value.
Individual readings will reset to current temperature, humidity, etc.
Check for debris or ice in cups.
Check mounting location. Look for obstructions that prevent the wind from reaching the
sensor.
In most cases, the wind sensor needs to be 4-6ft above the highest point on the roof in order
to clear nearby obstructions and read accurately.
A 50-foot clearance in all directions is best.
Push down firmly on the center of the cups to reseat them.
Cups are replaceable.
Replace wind cups:
1.
Loosen the screw on side of cups
2. Remove cups
3. Install new cups
4. Tighten screw
Note: The screw in the wind cups will fit on the flat side of the metal stem on the sensor.
Check that the wind cups attach to the sensor. Occasionally they can come off.
Check that the cups seat properly by pushing on the center of the cups.
La Crosse Technology, Ltd.
HI | LO TEMPERATURE/HUMIDITY RECORDS
WIND CUPS SPINNING SLOW OR NOT SPINNING
REPLACE WIND CUPS
WIND SPEED IS 0.00
Page 5