Table of Contents
Advertisement
C PIX (picture monitor output) connector (BNC type)
Supplies a video signal or video and character signals
together to a picture monitor.
Use the PICTURE MONITOR button on the MSU-900/
950, MONITOR SELECT button on the RCP-750/751,
and MONITOR SELECT control on the RM-B750 to
select the signal output from the PIX connector. When the
signal output from the PIX connector on the RCP-750/751
or the RM-B750 changes, the waveform output on the
waveform monitor also changes.
D SYNC connector
Connect to the synchronous signal input connector on a
waveform monitor or picture monitor.
E WF (waveform monitor output) connector (BNC
type)
Supplies a video signal to a waveform monitor.
The WAVEFORM MONITOR button on the optional
MSU-900/950, MONITOR SELECT button on the RCP-
750/751, or MONITOR SELECT control on the RM-B750
selects the signal output from the WF connector. Changing
the signal output from the WF connector on the RCP-750/
751 or the RM-B750 simultaneously changes the picture
on the picture monitor.
e REMOTE (remote control) connector (8-pin)
Connects to the MSU-900/950 Master Setup Unit, RCP-
750/751 Series Remote Control Panel or RM-B750
Remote Control Unit with an optional CCA-5-xx
connecting cable to transmit/receive control signals.
f ETHERNET connector
Supports the Ethernet system.
For details, consult your Sony service personnel.
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
PRÉCAUTION
Par mesure de sécurité, ne raccordez pas un connecteur
pour cåblage de périphérique qui pourrait avoir une tension
excessive à ce port. Suivez les instructions pour ce port.
ACHTUNG
Aus Sicherheitsgründen nicht mit einem Peripheriegerät-
Anschluss verbinden, der zu starke Spannung für diese
Buchse haben könnte. Folgen Sie den Anweisungen für
diese Buchse.
g INTERCOM/TALLY/PGM (program audio)
connector (D-sub, 25-pin)
Inputs/outputs intercom, tally, or program audio signals.
Connects to an intercom, tally, or program audio connector
of an intercom system.
h MIC REMOTE (microphone remote control)
connector (D-sub, 15-pin)
Connects to an external control unit such as an audio
mixer. With the connected unit, you can set the
microphone input level of the video camera to –60, –50, –
40, –30, or –20 dB.
i WF MODE (waveform monitor mode) connector
(4-pin)
Connects to the corresponding connector on a waveform
monitor to allow the sequential monitoring of signals.
j AC IN (AC power input) connector
Connects to an AC power source using the supplied AC
power cord. Secure the power cord to the CCU-590/590P
using the supplied plug holder.
Function and Location of Parts and Controls
9
Advertisement
Table of Contents
