Self-Diagnostics Results Of The Camera Internal Boards; Rom Version Indication; Exiting The Self-Diagnostic Mode; When An Error Occurs - Sony CCU-590 Operation Manual

EN board
Component: Setting status of the component output
signal from the OUTPUT connector and status of the
sync signal added to the component Y/G output signal
from the OUTPUT connector
Composite: Setting status of the composite output signal
from the OUTPUT connector
Power: EN board power supply status
VDA: Power supply status of the VDA board on the rear
PLD: Status of the PLD mounted on the EN board
Board ID: ID number of the EN board
Self-diagnostics results of the
camera internal boards
Press the CHARACTER button on the RCP-750/751
remote control panel or the RM-B750 while the last page
of the results of the self-diagnostics of the CCU-590/590P
internal boards is displayed on the monitor screen. The
results of a self-diagnosis of the internal boards of the
camera are displayed.

ROM version indication

Press the CHARACTER button on the RCP-750/751
remote control panel or the RM-B750 while the results of
self-diagnostics of the camera internal boards are
displayed on the monitor screen. The ROM version of each
device within the system is displayed.

Exiting the Self-diagnostic mode

Press the CHARACTER button on the RCP-750/751
remote control panel or the RM-B750 repeatedly to display
the ROM version indication page, then press the
CHARACTER button again.

When an error occurs

The error message is displayed on the picture monitor. In
such a case, the self-diagnostics page corresponding to the
board where the error has occurred appears by pressing the
CHARACTER button.
When you keep pressing the CHARACTER button, pages
are automatically turned to a screen with no characters
(character OFF screen).
15
Self-Diagnostics