Subaru BRZ 2017 Owner's Manual page 27

NOTICE
*
1
:
• Ensure the antenna wire (antenna feeder) is at least 20 cm (7.87 in.) away
from any of the vehicle's ECUs or sensors.
• Do not tie the antenna wire together with other vehicle wiring. Also, it is
important the antenna wire does not run parallel with other vehicle wiring.
The antenna wire route should follow the contours of the metal body panels.
• Securely ground the RF-transmitter near the device itself.
*
2
: Handy RF-transmitters can even be used above the passenger seat inside
the cabin.
NOTE:
After installing an RF-transmitter, check if all vehicle installed electronic devices
are receiving interference or not in the vehicle conditions outlined below. Check
using both standby receive mode and send mode.
• The push-button ignition switch is in "ON" mode.
• When the engine is running
• While driving at various speeds
Scrapping your SUBARU
The SRS airbag and seatbelt pretensioner devices in your SUBARU contain
explosive chemicals. If the vehicle is scrapped with the airbags and seatbelt
pretensioners left as they are, this may cause an accident such as fire. Be
sure to have the systems of the SRS airbag and seatbelt pretensioner
removed and disposed of by a qualified service shop or by any authorized
SUBARU dealer or repairer, or another duly qualified and equipped profes-
sional, before you scrap your vehicle.
27