Subaru BRZ 2017 Owner's Manual page 239

Within 5 seconds after the indicator lights turn off, release
STEP 5
. Then, press the switch again within 2 seconds of
releasing it.
The hill start assist ON indicator will illuminate and then turn off.
Turn the push-button ignition switch off. Then, restart the
STEP 6
engine and check that the hill start assist ON indicator is
illuminated.
The hill start assist system is enabled when the indicator is illumi-
nated.
To disable the hill start assist system, perform the above
through
STEP 6
■
When enabling the hill start assist system
●
If the hill start assist ON indicator does not illuminate or if an incorrect
operation is performed, turn the push-button ignition switch off and then
restart the enabling procedure from
●
If is pressed and held for approximately 30 seconds or more, the
Vehicle stability control (VSC) off indicator and Traction Control System
OFF indicator will turn off and subsequent operations of the switch will be
rejected. In this case, the Vehicle stability control (VSC) system will oper-
ate in normal mode. (→P. 233) To enable
ignition switch off and then restart the engine.
again.
2-4. Using other driving systems
STEP 4 .
, turn the push-button
2
STEP 1
239