Table of Contents
Advertisement
Before installing the security bezel, if you have removed the rack latches, reinstall them. See "Install the rack
latches" on page 77.
To install the security bezel, complete the following steps:
Attention: Before you ship the rack with the server installed, reinstall and lock the security bezel into place.
Step 1.
If the key is held inside the security bezel, remove it out of the security bezel.
Figure 57. Key removal
Step 2.
Carefully insert the tabs on the security bezel into the slots on the right rack latch. Then, press and
hold the release latch
Figure 58. Security bezel installation
1
and pivot the security bezel inward until the other side clicks into place.
.
Chapter 5
Hardware replacement procedures
85
Advertisement
Table of Contents
