Table of Contents
Advertisement
Figure 3. Front I/O assembly
Table 3. Components on the front I/O assembly
Callout
1
XClarity Controller USB connector
3
Power button with power status LED
5
System ID button with system ID LED
1
XClarity Controller USB connector
Depending on the setting, this connector supports USB 2.0 function, XClarity Controller management
function, or both.
• If the connector is set for USB 2.0 function, you can attach a device that requires a USB 2.0 connection,
such as a keyboard, a mouse, or a USB storage device.
• If the connector is set for XClarity Controller management function, you can attach a mobile device
installed with the application to run XClarity Controller event logs.
• If the connector is set to have both functions, you can press the system ID button for three seconds to
switch between the two functions.
2
USB 3.0 connector
Used to attach a device that requires a USB 2.0 or 3.0 connection, such as a keyboard, a mouse, or a USB
storage device.
3
Power button with power status LED
You can press the power button to turn on the server when you finish setting up the server. You also can hold
the power button for several seconds to turn off the server if you cannot turn off the server from the operating
system. The power status LED helps you to determine the current power status.
Callout
2
USB 3.0 connector
4
Network activity LED
6
System error LED
Chapter 3
.
15
Server components
Advertisement
Table of Contents
