Table of Contents
Advertisement
Figure 33. M.2 drive installation
Step 1.
Insert the M.2 drive at an angle of approximately 30 degrees into the connector.
Note: If your M.2 backplane supports two M.2 drives, insert the M.2 drives into the connectors at
both sides.
Step 2.
Rotate the M.2 drive down until the notch
Step 3.
Slide the retainer forward (toward the connector) to secure the M.2 drive into place.
Attention: When sliding the retainer forward, ensure that the two nubs
4
small holes
Figure 34. Instruction for sliding the retainer
on the M.2 backplane. Once they enter the holes, you will hear a soft "click" sound.
1
catches on the lip of the retainer
.
Chapter 5
2
.
3
on the retainer enter the
Hardware replacement procedures
65
Advertisement
Table of Contents
