Electrical Connection - Panasonic CQ-MR505N Service Manual

Electrical Connection

E
N
G
L
I
Cautions:
S
¡Confirm the note on page 4, and make connections to the connectors on car side.
H
¡This unit is designed to be used in a car having 12-volt negative ground battery system.
28
¡To prevent damage to the unit, be sure to follow the connection diagram below.
¡Remove the covering of the leads about 5 mm long from their end before connecting. (except for ISO
connector's cords)
¡Do not insert the power connector into the unit until the wiring is completed.
¡Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all
cables and keep cable terminals free from touching any metal parts.
Extension Cord (DIN/BATT/RCA/GND)
(Black)
Ground Lead
(Yellow)
BATTERY
Fuse (3.15 A)
RCA Cord
DIN Cord
Preamp Out Connector
(Front)
G ISO Antenna Adaptor
(If needed)
Antenna
Preamp Out Connector (Rear)
Sub Woofer Out
(Monaural)
(Only for CQ-MR505N
(White w/black
stripe)
38
CD Text recognizable CD changer
To a clean, bare metallic
part of the car chassis
Battery Lead
To the car battery,
continuous +12 V DC
(L)(White)
(R)(Red )
(L)(White)
(R)(Red)
C1
(Orange)
S.W-OUT
)
Speaker Lead
(Gray w/black stripe)
(White)
(Gray)
w/black stripe)
(See the next page about A1-A8, B1-B8 and C1.)
CQ-MR505/MR303N
CX-DP9061EN
<Back Side>
CD Changer
Control Connector
CH C-IN
E
CD Changer Input Cord
MD Player/Receiver
CQ-MR505/MR303N
B Power
Connector
(Yellow)
BATTERY 15A
(Black)
Fuse(15 A)
Resistor (1 k )
¶
(Red)
ACC
(Dark blue)
(Violet w/black stripe)
(Green
(Green) (Violet)
¡This unit can be connected to an
optional CD changer (CX-DP
9061/DP9060EN, CX-DP88N,
CX-DP801/DP803EN or CX-
DP601EN) and optional extension
cord.
¡For details consult your nearest
authorized Panasonic Dealer.
¡For connection to a CD changer,
refer to the operating instructions
of the CD changer (CX-DP90
61/DP9060EN, CX-DP88N, CX-
DP801/DP803EN or CX-DP
601EN).
A5
(Dark blue)
A7
A (Black)
A8
A5
A4
B7
B (Brown)
B8
B5
B6
B4
B3
B2
B1