¡Using the Rubber Cushion (Option)
(If there is an existing Rear Support Bracket on the fire wall of car.)
Cover Mounting Bolt w on the rear of the unit with Rubber Cushion, and mount it into the exist-
ing Rear Support Bracket.
3. Insert Trim Plate y.
4. After installation reconnect the nega-
tive ( | ) battery terminal.
To Remove the Unit
a) Remove the removable face plate. (See page 33.)
b) Remove Trim Plate y with a screwdriver as shown in the figure.
c) Pull out the unit while pushing the lock lever using screwdriver. (Fig. 7, Fig. 8)
d) Remove the unit pulling with both hands. (Fig. 9)
Fig. 7
Lock Lever
Screwdriver
y Trim Plate
Fig. 8
a
Rear Support Bracket
(Existing on the car)
Rubber Cushion
(Option)
wMounting Bolt
qMounting Collar
y Trim Plate
Screwdriver
1
2
a
CQ-MR505/MR303N
Fig. 9
E
N
G
L
I
S
H
27
37