Operating The Attachments; Stopping The Combine; Maintenance - New Holland CX720 Operator's Manual

SECTION 1 – GENERAL INFORMATION AND SAFETY

Operating the attachments

1. When coupling an attachment to the base unit,
never stand between the machine and the
attachment.
2. Make sure that no one is standing in front of the
machine when detaching an attachment.
3. Before operating the attachment, make sure that
there is no one on or near the machine.

Stopping the combine

1. Always lower the attachment to the ground when
parking the machine.
2. For safety's sake never leave the operator's
platform without first returning the ground speed
control lever to neutral, switching off the threshing
mechanism, engaging the parking brake and
stopping the engine. Furthermore, if leaving the
machine unattended, always remove the ignition
key and switch off the switch on the battery.

Maintenance

1. Follow the maintenance schedule with regard to
the machine servicing intervals.
Remember that the machine requires minor
attention from time to time. Also remember that
the time taken on maintenance will greatly extend
the life of the machine.
2. Never attempt to clean, lubricate or carry out any
adjustments on the combine while it is in motion
or while the engine is running.
3. Keep hands, feet and/or garments away from
moving parts. Check that all rotating parts are
correctly guarded.
4. Never work under the attachment without first en-
suring that the straw elevator hydraulic cylinder
4. Never attempt to remove crop or residues from a
plugged attachment while the machine is
running. Such an imprudence could cost life or
limb. In the event of a blockage, always
disengage the threshing mechanism, switch off
the harvester engine and apply the parking brake
before clearing the blockage.
3. When parking, always try to leave the machine on
level ground and apply the parking brake. If the
ground is sloping, apply the parking brake and
wedge the wheels.
safety latch is engaged or that it is securely sup-
ported on wooden blocks.
5. Always use suitable jack stands when carrying
out maintenance on the steering axle.
1–11