Airborne Noise Emission; Electromagnetic Compatibility (Emc); Vibration Level Information - New Holland CX720 Operator's Manual

SECTION 1 – GENERAL INFORMATION AND SAFETY

AIRBORNE NOISE EMISSION

In line with the European directive (CEE/86/188) and
national legislation, listed below are the noise levels
at the operator's ear measured in dBa, according to
the ISO 5131 standard.
The noise is measured with the engine and all
mechanisms engaged and running at normal
operating speed for the specified use of the product
and without crop flow through the machine. For
machines with a cab, the noise is measured with all
windows and doors closed and also in the open
position.
It should be noted that the noise level may exceed 85
dBa if the machine is operating with doors and/or
windows open.
In this case, the use of ear protection equipment is
recommended. In several
mandatory, so check local legislation.
Machine Engine model
model
CX720 CNH 675 TA/AG
CX740 CNH 675 TA/AH
CX760 CNH 675 TA/AJ
CX780 CNH 675 TA/AB
CX820 CNH 675 TA/AJ
CX840 CNH 675 TA/AB
CX860 IVECO F2B
CX880 IVECO F3A
countries this is
Noise level (dBa)
Cab doors and
windows closed
75
75
75
75
75
75
75
75
ELECTROMAGNETIC COMPATIBILITY
(EMC)
This product complies with the EEC directive 89/336
and its amendments
Interferences on electronic equipment if it is used in
conjunction with equipment which bears the CE
mark.
New Holland will take no liability for any problem
arising as a result of its product working in an
environment of other equipment which does not
comply with the EEC directive.
Disturbances remain possible if added non New
Holland equipment does not meet the standards. As
these interferences may result in serious malfunction
of the machine and/or create unsafe situations the
following instructions must be observed:
Each element of non New Holland equipment added
to this New Holland product must bear a CE mark.
The maximum power of emission equipment (radio,
telephones, etc.) must not exceed the limits imposed
by the national authorities of the country of usage of
the machine.
The electromagnetic field generated by the added
system must not exceed 24 V/m at any moment and
at any location in the proximity of electronic
components and the network between them over the
entire machine.

VIBRATION LEVEL INFORMATION

The vibration level for the arms to which the operator
of this machine is exposed under normal operating
conditions is below the 2.5 m/sec
mean square (RMS) value. The vibration level for the
whole body is below the 0.5 m/sec@ RMS value.
This information and measuring methods are in line
with the European Machinery Directive 98/37/EC
paragraph 3.6.3.
on Electromagnetic
weighted root
@
1–17