Pre Installation Configuration; Communicator Installation Configuration - DSC PowerSeries Neo 3G2080E Installation Manual

Cellular alarm communicator, internet and hspa dual-path alarm communicator, internet alarm communicator

Hide thumbs Also See for PowerSeries Neo 3G2080E:

Installation manual (65 pages)

Installation manual (21 pages)

Table Of Contents

Table of Contents

Model

Current Consumption

Standby Current

Alarm (Transmitting)

Current

Operating Frequency

Typical Antenna Gain

Environmental Specifications

Operating Temperature

Humidity

Mechanical Specifications

Board Dimensions (mm)

Weight (grams) with

bracket

Communicator Receiver/Panel

3G2080(R)E

Receiver

TL2803G(R)E Panel

NOTE: Enter [*][8][Installer Code][900] at keypad to view the panel version number.

Encryption

The communicator uses 128 Bit AES encryption. Encryption can only be enabled from the monitoring station receiver. Each

receiver (Ethernet 1 and 2, cellular 1 and 2) can independently have encryption enabled or disabled. When encryption is

enabled, the central station will configure the device to encrypt communications the next time the communicator module per-

forms a communication to that receiver.

NOTE: Packets will start being encrypted only after the next event is sent to that receiver, or if the unit is restarted.

Before leaving the installation site, the communicator TL2803G(R)E Ethernet line shall be connected via an APPROVED

(acceptable to the local authorities) Network Interface Device (NID). All wiring shall be performed according to the local

electrical codes.

This HSPA(3G)/dual- path alarm communicator shall be installed by service persons only (service person is defined as a per-

son having the appropriate technical training and experience necessary to be aware of hazards to which that person may be

exposed to in performing a task and can also take measures to minimize the risks to that person or other persons). The Com-

municator shall be installed and used within an environment that provides the pollution degree max 2, overvoltages category II,

in non-hazardous, indoor locations only. This manual shall be used with the installation manual of the panel which is con-

nected to the communicator. All instructions specified within the panel manual must be observed.

All the local rules imposed by local electrical codes shall be observed and respected during installation.

3G2080(R)E

Cellular only

Power is supplied from the panel's PC-Link header or a PCL-422 module in remote cabinet

installations. In remote cabinet installations, the PCL-422 module located with the communicator is

90mA @ 13.66V

100 × 150 × 15

310

Table 2: Compatible Receivers and Panels

Sur-Gard System I-IP Receiver, version 1.13+

Sur-Gard System II Receiver, version 2.10+

Sur-Gard SG-DRL3-IP, version 2.30+ (for Sur-Gard System III Receiver)

Sur-Gard SG-DRL4-IP version 1.20+ (for Sur-Gard System IV Receiver)

Sur-Gard SG-DRL5-IP version 1.00+ (for Sur-Gard System 5 Receiver)

HS2016

HS2016-4

HS2032

HS2064

HS2128