Ctcss/Dcs Operation; Ctcss Operation - Yaesu FT-2800M Operatiing Manual

A
DVANCED

CTCSS Operation

Many repeater systems require that a very-low-frequency audio tone be superimposed on
your FM carrier in order to activate the repeater. This helps prevent false activation of the
repeater by radar or spurious signals from other transmitters. This tone system, called
"CTCSS" (Continuous Tone Coded Squelch System), is included in your FT-2800M, and is
very easy to activate.
CTCSS setup involves two actions: setting the Tone Mode and then setting of the
Tone Frequency. These actions are set up by using the Set (Menu) mode, selec-
tions #28 (SQ TYP) and #27 (SQ TNF).
1. Press and hold in the [ MHz ( SET )] key for one second, then rotate the DIAL knob to
select "28 SQ TYP."
2. Press the [ MHz ( SET )] key, then rotate the DIAL knob so that "T ENC" appears on the
display; this activates the CTCSS Encoder, which allows repeater access.
You may notice an additional "DC ENC" and "DCS" appearing while you
rotate the DIAL knob in this step. We'll discuss the Digital Code Squelch sys-
tem shortly. And also, "T+DCS" and "TSQ+DC" appearing while you rotate the DIAL
knob in this step. This is a Split Tone Operation, describe later.
3. Rotating the DIAL knob one more click clockwise in the above step will cause "TSQ" to
appear. When "TSQ" appears, this means that the Tone Squelch system is active, which
mutes your FT-2800M's receiver until it receives a call from another radio sending out
a matching CTCSS tone. This can help keep your radio quiet until a specific call is
received, which may be helpful while operating in congested areas.
4. When you have made your selection of the
CTCSS tone mode, press the [ MHz ( SET )]
key momentarily, then rotate the DIAL knob
one click counter-clockwise to select Menu
"27 SQ TNF." This Menu selection allows
setting of the CTCSS tone frequency to be
used.
5. Press the [ MHz ( SET )] key to enable adjust-
ment of the CTCSS frequency.
6. Rotate the DIAL knob until the display indicates the Tone Frequency you need to be
using.
7. When you have made your selection, press and hold in the [ MHz ( SET )] key for one
second to save the new setting and exit to normal operation.
24
O
PERATION
CTCSS/DCS O
PERATION
CTCSS TONE FREQUENCY ( Hz )
67.0 69.3 71.9
82.5 85.4 88.5
100.0 103.5 107.2
123.0 127.3 131.8
151.4 156.7 159.8
171.3 173.8 177.3
189.9 192.8 196.6
210.7 218.1 225.7
250.3 254.1 –
FT-2800M O
74.4 77.0 79.7
91.5 94.8 97.4
110.9 114.8 118.8
136.5 141.3 146.2
162.2 165.5 167.9
179.9 183.5 186.2
199.5 203.5 206.5
229.1 233.6 241.8
– – –
M
PERATING ANUAL