Repeater Operation; Repeater Splits; Standard Repeater Shift - Yaesu FT-2800M Operatiing Manual

The FT-2800M includes a host of convenience features which makes operation on amateur
repeaters both efficient and enjoyable.

Repeater Splits

This transceiver offers three methods of setting up split-frequency operation on repeaters:
[ 1 ] Manual selection of preset repeater shifts;
[ 2 ] Automatic Repeater Shift (ARS), providing automatic activation of repeater shifts
during designated repeater frequency subbands; and
[ 3 ] Independently stored transmit and receive frequencies (typically not corresponding
to established repeater frequency shifts).

[ 1 ] Standard Repeater Shift

To activate the standard shift manually, you may use the Set (Menu) mode:
1. Press and hold in the [ MHz ( SET )] key for one second, then rotate the DIAL knob to
select "21 RPTR."
2. Press the [ MHz ( SET )] key, then rotate the DIAL knob to select the desired shift direc-
tion (–RPTR, +RPTR, or SIMP).
3. Press and hold in the [ MHz ( SET )] key for one second to save your new setting and exit
to normal operation.
You also may program one of the Microphone's programmable keys ([ P1 ] ~ [ P4 ])
to allow quick access to the above procedure. See page 45 for details on the setup
of the programmable keys.
With repeater shift activated, you can temporarily reverse the transmit and receive frequen-
cies by pressing the [ REV ( DW )] key (or microphone's [ B ] key). Use this feature to display
the transmit frequency without transmitting, and to check the strength of signals on a re-
peater uplink frequency (so as to determine whether or not a particular station is within
"Simplex" range, for example).
The repeater offset is fixed to 600 kHz from the factory. You can change the offset by the
following procedure, if needed for vacation travel or other purposes:
1. Press and hold in the [ MHz ( SET )] key for one second, then rotate the DIAL knob to
select "24 SHIFT."
2. Press the [ MHz ( SET )] key, then rotate the DIAL knob to set the desired offset. Note that
the resolution of the "standard" repeater shift is to the nearest 50 kHz multiple.
3. Press and hold in the [ MHz ( SET )] key for one second to save your new setting and exit
to normal operation.
Do not use this procedure for programming of an "odd split" type repeater pair!
The process for programming odd splits is shown on page 23.
FT-2800M O
PERATING
A
DVANCED
R O
EPEATER
M
ANUAL
O
PERATION
PERATION
21