Lubrication; Cleaning And Anticorrosion Measures; Flushing Cooling Water Passage - Yamaha VF200 Owner's Manual

1
1. Air intake
2. Drain the cooling water completely out of
the outboard motor. Clean the body thor-
oughly.
EMU41072

Lubrication

1. Change the gear oil. For instructions,
see page 92. Check the gear oil for the
presence of water that indicates a leaky
seal. Seal replacement should be per-
formed by an authorized Yamaha dealer
prior to use.
2. Lubricate all grease fittings. For further
details, see page 79.
TIP:
For long-term storage, fogging the engine
with fogging oil is recommended. Contact
your Yamaha dealer for information about
fogging oil and procedures for your outboard
motor.
EMU41154
Cleaning and anticorrosion
measures
1. Wash the exterior of the outboard motor
using fresh water, and then dry the out-
board motor completely. For instructions
on cleaning the outboard motor, see
page 72. NOTICE: Do not spray water
into the air intake.
2. Spray the outboard motor powerhead
ZMU06944
[ECM01841]
with "Yamaha Silicone Protectant."
3. Wax the cowling with a non-abrasive
wax such as "Yamalube Professional
Polish."
EMU40964

Flushing cooling water passage

Perform this procedure right after operation
for the most thorough flushing.
ECM01531
NOTICE
Do not perform this procedure while the
engine is running. The water pump may
be damaged and severe damage from
overheating can result.
1. Disconnect the garden hose connector
from the fitting on the bottom cowling.
1
1. Fitting
2. Garden hose connector
3. Garden hose adapter
2. Connect the garden hose to the garden
Maintenance
3
2
ZMU08065
73