System Overview - Fujitsu YOKOGAWA AF220 Application Note

4.2 System overview

A typical system environment is depicted in the figures 1-2 to 1-4. Depending on the
operation mode, the programmer can be used as stand-alone programmer or it can be
connected to a PC via RS-232C or Ethernet interface.
When using the programmer as stand-alone system then
the following components have to be ordered
separately:
•
Flash Programmer AF220/221
•
Control Module FF201 for Fujitsu 16LX-series
•
Interface cable AZ210 or AZ211 or AZ212
(see chapter "Target Probe" below)
In case that the programmer wants to be controlled by a PC then additionally the
•
Remote Controller Software Package AZ290 (can be download from homepage) and
•
RS-232C cable AZ221/AZ222 or twisted Pair Ethernet cable
have to be ordered, too
Figure 1-3: PC connection via RS-232C
If an own software front-end wants to be development then the library-package AZ291 has
to be ordered additionally.
© Fujitsu Microelectronics Europe GmbH
FLASH PROGRAMMER YOKOGAWA AF220/221
Introduction
Figure 1-2: Stand-alone Programmer
- 7 -
Figure 1-4: PC connection via Ethernet
MCU-AN-390087-E-V10