Pass/Error Adapter Az266 - Fujitsu YOKOGAWA AF220 Application Note

4.6 Pass/Error Adapter AZ266

This optional adapter uses the signal output from EXT.KEY to give the result of programming
(PASS / ERROR). It can be used to drive lamps or buzzer in e.g. a manufacture line.
Pin Signal Name
1 RES+
2 RES-
5 OAK1+
6 OAK1-
9 OAK2+
10 OAK2-
13 VCC
14 VCC
15 /User clear
17 /PASS
18 /ERROR
19 GND
20 GND
© Fujitsu Microelectronics Europe GmbH
FLASH PROGRAMMER YOKOGAWA AF220/221
Introduction
Figure 1-16: Pass/Error Adapter AZ266
Explanation
Reset Key
One Action Key 1
One Action Key 2
5V, max. 100mA
User clear input (low active)
Pass signal (low active, open collector: VOH=20V, IOL=40mA)
Error signal (low active, open collector: VOH=20V, IOL=40mA)
GND
Table 1-2: Pinout of Pass/Error Adapter AZ266
- 11 - MCU-AN-390087-E-V10