Vermont Castings Dutchwest 2465 Homeowner's Installation And Operating Manual page 27

Fig. 51 Remove mounting screws, pressure regulator tower
and spring and diaphragm assembly.
E
F
Fig. 52 Replace regulator.
FC108
Pilot Orifice Conversion
SIT
1. Locate pilot. (Fig. 49)
regulator
2. Replace pilot orifice.
conversion
Pilot Type 1
10/03
• Remove pilot hood by lifting up. (Fig. 53) Do not
remove snap ring to remove pilot hood. NOTE: It is
not necessary to remove the pilot tube for conver-
sion.
• Remove pilot orifice with allen wrench. (Fig. 54)
• Install the conversion orifice.
• Reinstall pilot hood. Be sure to align hood with
index tab.
Pilot type 2
• Loosen pilot hood turning counterclockwise using a
7/16" wrench. (Fig. 55) NOTE: You may use pen-
etrating oil to prevent pilot hood threads from seizing
up.
30001935
A
B
C
FC107
SIT820
valve conversion
10/03
D
FC108
Dutchwest Direct Vent / Natural Vent Gas Heater
Pilot Hood
Pilot
Bracket
Fig. 53 Remove pilot hood.
Index Tab
FC107
Snap Ring
Fig. 54 Remove pilot orifice.
Index
Marks
Pilot Bracket
Fig. 55 Remove pilot hood. (Your pilot may have a different
appearance).
• Remove pilot orifice with needlenose pliers. (Fig.
56) NOTE: Use a wrench to hold pilot tube in place
while removing the orifice.
• Install the conversion orifice.
• Reinstall pilot hood and tighten until mark on pilot
hood aligns with mark on pilot bracket.
NOTE: Be sure burner leg remains at a 90° angle to
firebox base after conversion.
Fig. 56 Remove pilot orifice.
Allen Wrench
CO105a
gas conversion
Pilot
1/28/00 djt
CO106a
DV360/580
Gas Conversion
Pilot2
1/28/00 djt
CO105
Gas Conversion
Pilot
2/15/99 djt
Pilot Orifice
CO106a
Gas Conversion
Pilot (Vermont)
7/19/99 djt
CO105a
CO106a
Pilot
CO105
CO106b
27