Maintenance - Ryobi ERO-2412VN User Manual

GB
FR DE ES
OPERATION
TO EMPTY THE DUST BAG ASSEMBLY (Fig. 4)
For more efficient operation, empty the dust bag when
it is no more than half full. This will permit the air to flow
through the bag better. Always empty and clean the dust
bag thoroughly upon completion of a sanding operation
and before placing the sander in storage.
To empty dust bag:
Unplug your sander.
Q
WARNING
Failure to unplug your sander could result in
accidental starting causing possible serious
personal injury.
Remove the dust bag assembly from the sander.
Q
Remove the dust bag from the frame.
Q
Shake out the dust.
Q
Replace the dust bag on the frame.
Q
Replace the dust bag assembly on the sander.
Q
LIVE TOOL INDICATOR
This tool features a Livetool indicator (7) which illuminates
as soon as the tool is connected to the supply. This warns
the user that the tool is connected and will operate when
the switch is pressed.

MAINTENANCE

WARNING
The tool should never be connected to a power
supply when you are assembling parts, making
adjustments, cleaning, performing maintenance,
or when the tool is not in use. Disconnecting the
tool will prevent accidental starting that could
cause serious injury.
WARNING
When servicing use only identical Ryobi
replacement parts. Use of any other parts may
create a hazard or cause product damage.
GENERAL
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
IT NL PT DK SE FI NO RU PL CZ
English
WARNING
Do not at any time let brake fluids, gasoline,
petroleumbased products, penetrating oils,
etc., come in contact with plastic parts. They
contain chemicals that can damage, weaken, or
destroy plastic.
Electric tools used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to
accelerated wear and possible premature failure because
the fiberglass chips and grindings are highly abrasive
to bearings, brushes, commutators, etc. Consequently,
we do not recommended using this tool for extended
work on these types of materials. However, if you do
work with any of these materials, it is extremely important
to clean the tool using compressed air.
WARNING
Always wear safety goggles or safety glasses
with side shields during power tool operation or
when blowing dust. If operation is dusty, also
wear a dust mask.
LUBRICATION
All of the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore,
no further lubrication is required.
CLEANING THE SCRUBBING PADS
To ensure longer life and optimum performance,
periodically clean all sanding residue and foreign
materials from the scrubbing pads. This can be done
simply by rinsing the pad with warm water untill all foreign
material has been washed away. After cleaning, gently
squeeze the pad to remove excess water and allow
pad to dry. Always store pads and sanding sheets flat in a
cool dry location.
CLEANING THE SANDING SHEETS
The sanding sheets that came with your sander are
made to be re-used. Therefore, it is important that they
be cleaned periodically to remove sanding residue and
foreign material that can accumulate over time.
To clean sanding sheets, rub the sheets with a hard rubber
block. You can also use the clean rubber sole of a shoe.
WARNING
Always remove scrubbing or sanding pad from
sander before cleaning. Failure to do so could
cause serious personal injury.
3
HU RO LV LT EE HR SI SK GR TR