Table of Contents
Advertisement
Network Camera User's Guide
Appendix C: Troubleshooting &
Frequently Asked Questions
Question
The video and audio
codec is adopted in the
Network Camera.
The maximum number
of users access Network
Camera simultaneously.
The
Network
Camera
can be used outdoors or
not.
Status LED does not
light up.
The network cabling is
required for the Network
Camera.
The
Network
Camera
will be installed and work
if a firewall exists on the
network.
The
username
password for the first
time
or
after
factory
default reset
Forgot
the
username
and password
Features
The Network Camera utilizes JPEG compression to providing
high quality images. JPEG is a standard for image
compression and can be applied to various web browsers
without the need to install extra software.
The audio codec is ADPCM compression.
The maximum number of users is depend on the total
bandwidth accessed to Network Camera from clients. The
data throughout of Network Camera is around 5~6Mbps.
Therefore, the maximum number of connected clients is
varying by settings of resolution and frame rate. Obviously,
the performance of the each connected client will slow down
when many users are logged on.
The Network Camera is not weatherproof. It needs to be
equipped with a weatherproof case for outdoors using.
However, equipped with a weatherproof case will disable the
audio function of Network Camera.
Install Network Camera
• Check and confirm that the standard AC adaptor, included
in packaged, is used. Secure the power connector and re
power it on again.
• If the problem is not solved, the Network Camera might be
faulty. Contact your dealer for further help.
The Network Camera uses Category 5 UTP cable allowing 10
and/or 100 Base-T networking.
If a firewall exists on the network, port 80 is open for ordinary
data communication. The Network Camera uses port
80(default) only. This port (or the port you specify from the
Configuration screen if you change the default port) needs to
be opened on the firewall.
and
Username = admin and leave password blank.
Note that it's all case sensitivity.
Follow the steps below.
1. Restore the factory default setting by press pressing and
holding down more than 8 seconds when power on
80/95
Answer or Resolution
Advertisement
Table of Contents
