Kenwood KDC-230UI Instruction Manual page 12

AUDIO SETTINGS
[TRE ADJUST] [TRE CTR FRQ]
[TRE LEVEL]
[PRESET EQ] [DRIVE EQ]/[TOP40]/[POWERFUL]/[ROCK]/[POPS]/[EASY]/[JAZZ]/
[NATURAL]/[USER]: Selects a preset equalizer suitable to the music genre.
• Select [USER] to use the settings made in [EQ PRO].
Default:
/
[BASS BOOST] [LV1]/[LV2]/[LV3]: Selects your preferred bass boost level. ; [OFF]: Cancels.
[LOUDNESS] [LV1]/[LV2]: Selects your preferred low or high frequencies boost to produce a
well-balanced sound at low volume. ; [OFF]: Cancels.
[SUBWOOFER SET] [ON]: Turns on the subwoofer output. ; [OFF]: Cancels.
[LPF SUBWOOFER] [THROUGH]: All signals are sent to the subwoofer. ; [85HZ]/[120HZ]/
[160HZ]: Audio signals with frequencies lower than 85 Hz/120 Hz/160 Hz are
sent to the subwoofer.
[SUB-W PHASE] [REVERSE] (180°)/[NORMAL] (0°): Selects the phase of the subwoofer output
to be in line with the speaker output for optimum performance.
• Selectable only if a setting other than [THROUGH] is selected for [LPF
SUBWOOFER].
[FADER] [R15] to [F15] ([0]): Adjusts the front and rear speaker output balance.
[BALANCE] [L15] to [R15] ([0]): Adjusts the left and right speaker output balance.
[VOLUME OFFSET] For AUX: [–8] to [+8] ([0]) ; For other sources: [–8] to [0]: Presets the initial
volume level of each source.
(Before adjustment, select the source you want to adjust.)
12
ENGLISH
[10.0KHZ]/[12.5KHZ]/[15.0KHZ]/[17.5KHZ]:
Selects the center frequency.
[–8] to [+8]: Adjusts the level.
Default:
/ /
: [+3]
/ : [USER]
: [POWERFUL]
[SOUND RECNSTR]
(Sound
reconstruction)
• [SUB-W LEVEL]/[SUBWOOFER SET]/[LPF SUBWOOFER]/[SUB-W PHASE] is
: [+1]
selectable only if [SWITCH PREOUT] is set to [SUB-W]. (Page 4)
• [SUB-W LEVEL]/[LPF SUBWOOFER]/[SUB-W PHASE] is selectable only if
[SUBWOOFER SET] is set to [ON].
[ON]: Creates realistic sound by compensating the high-frequency
components and restoring the rise-time of the waveform that are lost
in audio data compression. ; [OFF]: Cancels.