Chapter 2: Camera Setup; Hardware Setup - Veo Observer User Manual

Camera Setup
Before installing the Veo Observer Camera, you should have an available Ethernet
LAN connection (RJ-45 port). To view the camera's image or make any manual
configuration changes, you will need a Windows PC with Internet Explorer 5.0 or
higher, also connected to the LAN.

2.1 Hardware Setup

Connecting the Ethernet cable
Connecting the power adapter
Step 1. Plug the included Ethernet cable into the RJ-
45 connector at the back of the camera as shown.
Step 2. Plug the other end of the Ethernet cable into
any available LAN port. A typical home
router/gateway connection is shown on the left.
Step 3. Connect the power supply to the back of the camera as
shown, and then plug the supply into an available power outlet.
CAUTION: Make sure to only use the power
adapter supplied with your Veo Observer
Network Camera. Using a non-approved power
adapter may damage the camera.
Page 7 of 65
2
Chapter