Connections; Connecting A Tv Antenna / Cable / Satellite - Venturer PLV16070 Instruction Manual

Connecting a TV Antenna / Cable / Satellite

To view television channels correctly, a signal must be received from one of the following sources:
- An indoor or outdoor aerial antenna
- A cable system
- A satellite system
using Direct-connect antenna
To optimize TV reception, try adjusting the
orientation and position of the direct-connect
antenna.
using a Different antenna
To TV ANTENNA terminal
(cable not included)
how to connect the auxiliary antenna
1. Hold the connector of auxiliary antenna and rotate
the nut to the ANTENNA RF IN terminal on the
side of the TV.
2. Remove the cap on the base of Auxiliary Antenna.
3. Hold the antenna rod of Auxiliary Antenna and rotate
the nut to the base until it is fastened.
4. Extend the antenna rod and adjust position for
optimal reception.

connectionS

removing Direct-connect antenna Before
connecting a different antenna or a coaxial
cable, you need to remove the direct-connect
antenna first.
- 7 -
Hold the direct-connect antenna
and rotate the nut as shown below
to remove.
Cable TV (without a CATV converter)
Combination VHF/UHF antenna
(ATSC / NTSC signal)
Separate VHF/UHF antenna
(ATSC / NTSC signal)
Auxiliary antenna
(included with this product)
3