Canon WFT-R10 Advanced User's Manual page 155

68: Cannot connect to wireless LAN terminal. Retry from the
beginning.
Did you hold down the WPS (Wi-Fi Protected Setup) button on the access point
for the specified period of time?
• Hold down the WPS button for the period of time specified in the instruction manual
of the access point.
Are you trying to establish a connection near the access point?
• Try establishing the connection when both devices are within reach of each other.
69: Multiple wireless LAN terminals have been found. Cannot
connect. Retry from the beginning.
Another access point is using the PBC (Pushbutton connection mode) of WPS
(Wi-Fi Protected Setup) to establish a connection.
• Try connecting after a while or use PIN mode (PIN code connection mode) for the
connection (
71: Cannot connect to receiver camera
Are you following the correct procedure to establish a connection with the
receiver camera?
• Make sure to follow the correct procedure for controlling the receiver cameras
( , ).
Are the receiver cameras too far from the sender camera?
• Bring the receiver cameras closer to the sender camera.
Are there many devices in your surroundings that emit radio waves?
• Move away from that area and try controlling the receiver cameras again (
72: Cannot connect to sender camera
Are you following the correct procedure to establish a connection with the sender
camera?
• Make sure to follow the correct procedure for controlling the sender camera
( , ).
Is the sender camera too far from the receiver cameras?
• Bring the sender camera closer to the receiver cameras.
Are there many devices in your surroundings that emit radio waves?
• Move away from that area and try controlling the sender camera again (
).
155
, ).
, ).