Haier HWD120-B14876 User Manual page 29

9-14
9-13
9-15
WARNING!
Ensure always that all connections(power supply,drain and fresh water hose)
are firm,dry and leack free!
Take care these parts are never to be crushed,kinked,or twisted.
If the supply cord is damaged,it must be replaced by the service agent (see
warranty card) in order to avoid a hazard.
Note: Self Clean
After each installation or long periods of disuse,before first use and for regular
maintenance run programme Self Clean with no load and special machine
cleaner to remove possibly corruptive residues.
9.7 Fresh Water Connection
Make sure that the gaskets are inserted.
1. Connect the water inlet hose with the angledend to
the appliance(Fig.9-13). Tighten the screw joint by hand.
2. The other end connect to a water tap with a 3/4 thread
(Fig.9-14).
9.8 Electrical Connection
Before each connection check if:
power supply, socket and fusing are appropriate to
the rating plate.
the power plug and socket are strictly according.
Put the plug into the socket(Fig. 9-15).
9-Installation
29