Power Trim And Tilt Switch On Bottom Cowling; Power Trim And Tilt Switches - Yamaha F250B Owner's Manual

Components
DN
EMU26154
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on the
side of the bottom cowling. Pushing the switch
" " (up) trims the outboard motor up, and
then tilts it up. Pushing the switch "
tilts the outboard motor down and trims it
down. When the switch is released, the out-
board motor will stop in its current position.
For instructions on using the power trim and
tilt switch, see page 61.
EWM01031
WARNING
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
falling overboard and could distract the
operator, increasing the risk of collision
with another boat or an obstacle.
26
UP
ZMU05822
" (down)
EMU35851

Power trim and tilt switches

The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pushing the switch "
board motor up, and then tilts it up. Pressing
the switch " " (down) tilts the outboard motor
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position.
UP
1
DN
1
1. Power trim and tilt switch
" (up) trims the out-
UP
ZMU05835
DN
1