Flushing Power Unit; Checking Painted Surface Of Outboard Motor - Yamaha F250B Owner's Manual

3. Grease all grease fittings. For further de-
tails, see page 74.
TIP:
For long-term storage, fogging the engine
with oil is recommended. Contact your
Yamaha dealer for information about fogging
oil and procedures for your engine.
EMU34741

Flushing power unit

Perform this procedure right after operation
for the most thorough flushing.
ECM01530
NOTICE
Do not perform this procedure while the
engine is running. The water pump may be
damaged and severe damage from over-
heating can result.
1. After shutting off the engine, unscrew the
garden hose connector from the fitting on
the bottom cowling.
1. Fitting
2. Garden hose connector
3. Garden hose adapter
2. Screw the garden hose adapter onto a
garden hose, which is connected to a
fresh water supply, and then connect it to
the garden hose connector.
3. With the engine off, turn on the water tap
and let the water flush through the cool-
ing passages for about 15 minutes. Turn
off the water and disconnect the garden
hose adapter from the garden hose con-
nector.
4. Reinstall the garden hose connector onto
the fitting on the bottom cowling. Tighten
the connector securely. NOTICE: Do not
leave the garden hose connector
loose on the bottom cowling fitting or
let the hose hang free during normal
operation. Water will leak out of the
connector instead of cooling the en-
gine, which can cause serious over-
heating. Be sure the connector is
tightened securely on the fitting after
flushing the engine.
TIP:
When flushing the engine with the boat in the
water, tilting up the outboard motor until it is
completely out of the water will achieve better
results.
EMU28461
Checking painted surface of outboard
motor
Check the outboard motor for scratches,
nicks, or flaking paint. Areas with damaged
paint are more likely to corrode. If necessary,
clean and paint the areas. A touch-up paint is
available from your Yamaha dealer.
Maintenance
[ECM00541]
69