Battery Life Information - Standard Horizon RAM4X Owner's Manual

Battery Life Information

When the "
tery soon.
If the RAM4X will be unused for a long period of time, be sure to fully charge the built-in battery
before storing it. When the RAM4X is stored for an extended period, recharge the built-in battery
every six months to prevent it from over-discharging.
Connecting the RAM4X and the Transceiver
Once the transceiver and the RAM4X have been connected, and the settings have been
stored to each other, when both are turned ON, they are automatically connected. Up to
four RAM4X remote microphones can be connected at the same time.
Keep the device away from 802.11b/g/n Wi-Fi devices, Bluetooth devices, cordless phones,
transformers, heavy-duty motors, fluorescent lights, microwave ovens, and refrigerators to
prevent signal interference or loss.
1. When the RAM4X is turned ON for the first time after purchase,
the WI-FI SETUP screen will be displayed automatically.
2. Press the [YES] soft key on the RAM4X to display the WPS
screen.
3. Press and hold the POWER switch on the transceiver for about
10 seconds until the WPS screen is displayed.
NOTE: If the SCU-30 is not connected to the transceiver, a
warning screen will be displayed. In that case, press
the [OK] soft key, check the connection between the
transceiver and the SCU-30, and then perform step 3.
: Full battery power
: Enough battery power
: Low battery power
: Poor battery power. Charge battery.
: Charge the battery immediately
" icon appears, it is recommended that you charge the bat-
WARNING
WARNING
(RAM4X Screen)
押下後
(RAM4X Screen)
押下後
(Transceiver Screen)
5