Optional Accessories; Belt Clip Installation / Removal; Battery Charging - Standard Horizon RAM4X Owner's Manual

• The RAM4X is only floating / submersible * when the USB jack is properly sealed with jack cover.
*(IPX8 Specification for submersibility: 4.92 ft. (1.5 m) for 30 minutes.)
• Make sure that there is no dust, dirt or crack on the jack or the rubber gasket.
• Remove any dust and dirt before closing the cover.
• If you find any cracks on the jack cover or gasket, please contact Standard Horizon or your local
dealer to purchase a replacement.
• To keep the LCD, keypad and speaker grill clean and in top operating condition after exposure
to water: Clean the RAM4X with fresh water after exposure to salt water by rinsing the RAM4X
under a sink faucet or by dunking the RAM4X in a bucket of fresh water. After washing, use a
soft cloth and thoroughly dry all parts of the RAM4X.
Included Accessories and replacement part numbers
• SAD-17 USB Wall Charger (100-240 VAC)
• T9101648 USB Cable (Type USB "A" plug to Type USB micro "B" plug)
• CLIP-22 Belt Clip
• SCH-11 Belt Clip Hanger & Screws (U40412220 x 2 pcs)
• Hand Strap

Optional Accessories

• SCU-30
Wireless Access Point with 5 feet (1.5 m) Cable*
*(The SCU-30 firmware must be Ver. 2.00.00 or later.)
• SDD-14
USB DC Charger with Cigarette Lighter Plug

Belt Clip Installation / Removal

1. To install the Belt Clip CLIP-22, align it to the groove of
the rear panel, then press the Belt Clip downward until it
locks in place with a "Click".
2. To remove, pull the CLIP-22 latch tab away from the rear
panel to unlock the CLIP-22, then slide the CLIP-22 upward
to remove it.

Battery Charging

If the battery has never been used, or its
charge is depleted, charge the RAM4X ac-
cording to the following procedures:
1. Turn the RAM4X OFF.
2. Slide the USB jack cover button down to
open the cover.
3. Referring to the figure at the right, connect
the supplied USB Cable to the USB jack.
4. If the connection is correct, the RAM4X's LCD display will show the battery
charging icon.
5. A fully discharged RAM4X will be charged completely in approximately 4 hours.
When charging is completed, the battery charging icon will disappear.
NOTES
SAD-17
USB Cable
(Supplied)
3