Configuration Setup - Standard Horizon RAM4X Owner's Manual

WPS (Wi-Fi Protected Setup)
These menu item settings connect the transceiver and RAM4X using the WPS function.
[ ME NU ]
(Press)
(GX6000)
1.
[ ME NU ]
(Press and hold)
(GX2400)
2. Press the [YES] soft key to display the WPS screen.
3. Refer to "WPS (Wi-Fi Protected Setup)" of WI-FI SETUP
MENU of the RAM4X (Page 6) to display the WPS screen of
the RAM4X.
4. Connect the transceiver and the RAM4X using the procedure
in step 4 of "Connecting the RAM4X and the Transceiver"
(Page 5).
When "Subscribed" is displayed, connection of the trans-
ceiver and the RAM4X is completed. Once the connection is
completed, they will be connected automatically whenever the
transceiver and the RAM4X are turned ON.
Up to four RAM4X can be connected simultaneously to the
transceiver.

Configuration Setup

RAM4X operation is same as the enabled radio. This makes operation of the radio and
RAM4X microphone similar and much easier. The only difference is that the following
three items are added to CONFIGURATION SETUP:
LAMP
This menu selection is used to setup the illumination time of the display and keypad.
NOTE: This function is available for the GX6000 with the Radio firmware Ver2.00.06 or
later and the AIS firmware Ver. 1.00.05 or later.
[ ]  "SETUP"  "CONFIGURATION"  "LAMP"
1.
(RAM4X)
2. Rotate the DIAL/ENT knob to select the desired setting ("5sec"
is default).
OFF: Disables the display/keypad lamp illumination.
3/5/10/20/30sec: Illuminates the display/keypad for the
selected time when any key is pressed.
CONTINUOUS: Illuminates the display/keypad continuously.
3. Press the [SELECT] soft key to store the selected setting.
4. Press the CLEAR/
 "SETUP"  "WI-FI SETUP"  "WPS"
 "WI-FI SETUP"  "WPS"
key to return to radio operation.
押下後
9