Radio Settings - US Robotics Instant802 APSDK Administrator's Manual

Creating VWN 'Two' on Radio One with WPA security
To configure the second Virtual Wireless Network, repeat steps 1-3 as described above (in Configuring
Virtual Wireless Network "One" on Radio One) with the following differences:
• Create a second VLAN ID from the Web User Interface with a new SSID
• In the CLI commands, replace wlan0bssvwn1 with wlan0bssvwn2.

Radio Settings

Before configuring this feature, make sure you are familiar with the names of the interfaces as
described in "Understanding Interfaces as Presented in the CLI" on page
reference in a command determines whether a setting applies to a wired or wireless interface or to the
Internal or Guest network.
This table shows a quick view of Radio Settings commands and provides links to detailed examples.
Radio Setting Command
Get Radio Settings
Get IEEE 802.11 Radio Mode
Get Radio Channel
Get Basic Radio Settings
Get All Radio Settings
Get Supported Rate Set
Get Basic Rate Set
Configure Radio Settings
Get IEEE 802.11 Radio Mode
To get the current setting for radio Mode:
USR5453-AP# get radio wlan0 mode
g
Example
get radio
get radio wlan0
get radio wlan0 detail
get radio wlan0 mode
get radio wlan0 channel
get radio wlan0
get radio wlan0 detail
get supported-rate
get basic-rate
See detailed examples in:
"1. Turn the Radio On or Off" on page 233
"2. Set the Radio Mode" on page 233
"3. Enable or Disable Super G" on page 233
"4. Set the Beacon Interval" on page 233
"5. Set the DTIM Period" on page 233
"6. Set the Fragmentation Threshold" on page 233
"7. Set the RTS Threshold" on page 234
"8. Configure Basic and Supported Rate Sets" on page 234
Class Structure, Commands, and Examples - 230
Professional Access Point
Administrator Guide
190. The interface name you