Pride Victory 9 Technical Troubleshooting Manual page 8

From step 7
10. Remove the main shroud. See figure 11.
11. Remove the cover from the controller (8). See figure 12.
12. Unplug connectors 3f and 3e from connector 8e. See diagram 3.
13. Measure voltage across connectors 3f and 3e. See figure 13.
—— If your multimeter indicates 0VDC, then replace the controller
power harness (3) and retest the system.
—— If your multimeter indicates greater than 18VDC, then plug
connectors 3f and 3e back into connector 8e and go to the next step.
14. Unplug connector 7a from connector 8a. See diagram 3.
15. Measure voltage across pin 7 and pin 13 on connector 8a. See
figure 14.
—— If your multimeter indicates 0VDC, then replace the controller
(8) and retest the system.
—— If your multimeter indicates greater than 18VDC, then plug
connector 7a back into connector 8a and go to the next step.
16. Unplug connector 10a from connector 7d. (Connector 7d is
located under the front shroud, near the front wheel.) See
diagram 2.
17. Measure voltage across pin 4 and pin 10 on connector 7d. See
figure 15.
—— If your multimeter indicates 0VDC, then replace the controller
interface harness (7) and retest the system.
—— If your multimeter indicates greater than 18VDC, then plug
connector 10a back into connector 7d and go to the next step.
Figure 11. Victory 10 Main Shroud Removal (Victory 9 May
Differ Slightly in Appearance)
8 www.pridemobility.com
Figure 12. Victory 10 Controller (8) Cover
Removal (Victory 9 May Differ Slightly in
Appearance)
Figure 13. Connectors 3f and 3e
Figure 14. Connector 8a
Figure 15. Connector 7d
Victory 9/10 Technical Troubleshooting Guide