Beep Code #6 - Throttle Trip - Pride Victory 9 Technical Troubleshooting Manual

2. Separate the front and rear halves of the scooter. Refer to the
scooter owner’'s manual.
3. Measure resistance across pin 3 and pin 4 of connector 19a.
See figure 23 and diagram 3.
—— If your multimeter does not indicate about 30-65 ohms, then
go to the next step.
—— If your multimeter indicates about 30-65 ohms, then go to step 6.
4. Unplug connector 21a from connector 20a. See diagram 2.
5. Measure resistance across pin 1 and pin 2 on connector 20a.
See figure 24.
—— If your multimeter indicates about 30-65 ohms, then replace
the brake harness (21) and retest the system.
—— If your multimeter does not indicate about 30-65 ohms, then
replace the brake (20) and retest the system.
From step 3
6. Reassemble the scooter. Refer to the scooter owner’'s manual.
7. Remove the main shroud. See figure 11.
8. Remove the cover from the controller (8). See figure 12.
9. Unplug connector 5d from connector 8c. See diagram 3.
10. Measure resistance across pin 1 and pin 2 of connector 5d. See
figure 25.
—— If your multimeter indicates about 30-65 ohms, then replace
the controller (8) and retest the system.
—— If your multimeter does not indicate about 30-65 ohms, then
replace the motor/brake harness (5) and retest the system.

Beep Code #6 - Throttle Trip

Symptoms:
The controller (8) beeps six times.
Diagnosis:
The throttle pot (15) was not in the neutral position when the
key was inserted and turned to the ON position.
The throttle pot (15) neutral position is out of tolerance.
Solution:
Use the following procedure to clear the beep code:
1. Press the throttle control lever forward and backward to check
the throttle pot (15) spring tension. The throttle control lever
should be easy to press and spring back to the neutral position
when released.
—— If the throttle control level moves freely and springs back to
the neutral position when released, then go to the next step.
—— If the throttle control level feels like it is obstructed or does
not spring back to the neutral position when released, then
replace the throttle pot (15) and retest the system.
2. Remove the front and rear tiller shrouds and the console
assembly. See figure 16.
12 www.pridemobility.com
Figure 23. Connector 19a
Figure 24. Connector 20a
Figure 25. Connector 5d
Victory 9/10 Technical Troubleshooting Guide