Universal Remote Control MRF-300/RFX150 Installation Manual page 7

Copper colored
conductor is
GROUND
(Sleeve of
the Plug).
Silver colored
conductor is IR
DATA (Tip of
the Plug).
Daisy Chain Multiple MRF-300's to One RFX-150 RF Sensor
Use the cable with 3.5mm Stereo Mini
plugs on both ends to daisy chain as
many MRF-300's as you need. Simply
connect the RF OUT of the first to the
RF IN of the next and so on down the
line.
By daisy chaining MRF-300's, you can
easily control up to 90 identical com-
ponents.
Step 3 - Connect the RFX-150 to the RF IN, but DO NOT MOUNT IT!
Plug the 3.5mm plug
into the RFX-150's RF
OUT jack.
Connect the other
end of the cable to
one of the two RF IN
on the MRF-300,
MRF-300 B S
ASE TATION
When connecting to a components rear panel
IR Input, cut the flasher off of the wire, strip the
two conductors and connect to the rear panel
IR Input.The MRF-300 is only compatible with
standard IR Inputs, not proprietary control sys-
tems such as Control S.
RF OUT of the
first MRF-300 to
the RF IN of the
next MRF-300.
When connecting a single RFX-150 to the MRF-
300 utilize the cable with 3.5 mm plugs on both
ends. When you need a longer wire or are con-
necting up to three RFX-150's, use the cable
with a plug on one end and tinned ends. These
can be extended as much as 200', then connect-
ed to the green removable screw connector
(which plugs into the alternate RF IN). The RED
connects to 5V, the WHITE to DATA and the
BLACK connects to GROUND.
Page 4
RF OUT of the
RFX-150 to the
RF IN of the
MRF-300.