Save Configuration; Reboot System - ZyXEL Communications NSW Series User Manual

8.2.2 Sa ve C o nfig ura tio n
Click
C o nfig 1
Click
C o nfig 2
Alternatively, click
to the current configuration.
Note: Clicking the
unsaved changes are erased after you reboot the NSW.
8.2.3 Re b o o t Syste m
Re b o o t Syste m
load configuration one (
when you reboot. Follow the steps below to reboot the NSW.
In the
1
Ma inte na nc e
configuration one. The following screen displays.
Reboot System: Confirmation
Fig ure 45
Click again and then wait for the NSW to restart. This takes up to two minutes. This does not affect the
2
O K
NSW's configuration.
Click
C o nfig 2
Click
Fa c to ry De fa ult
NSW.
Reboot System: Confirmation
Fig ure 46
Chapter 8 Maintenance
to save the current configuration settings permanently to
to save the current configuration settings permanently to
on the top right-hand corner in any screen to save the configuration changes
Sa ve
or button does NOT save the changes permanently. All
Apply Add
allows you to restart the NSW without physically turning the power off. It also allows you to
), configuration two (
C o nfig 1
screen, click the
C o nfig 1
and follow steps 1 to 2 to reboot and load configuration two on the NSW.
and follow steps 1 to 2 to reboot and load default configuration settings on the
NSW Series User's Guide
) or the factory default configuration
C o nfig 2
button next to
Re b o o t Syste m
51
on the NSW.
C o nfig ura tio n 1
on the NSW.
C o nfig ura tio n 2
to reboot and load