Installation Configurations; Mobile Home Installation Requirements - United States Stove American Harvest 6039I Owner's Manual

INSTALLATION CONFIGURATIONS

Note: Where passage through a wall, or partition of combustible construction is desired, the installation
shall conform to CAN/CSA -B365
The American Harvest Multifuel Stove Model 6039/6039T may be installed as follows:
1) A freestanding unit
The American Harvest Multifuel Stove Model 6039I insert may be installed as follows:
1) In a pre-fab firebox (Factory Built)
2) In an existing masonry fireplace
3) As a build-in

MOBILE HOME INSTALLATION REQUIREMENTS

IN ADDITION TO THE STANDARD INSTALLATION INSTRUCTION, THE FOLLOWING
REQUIREMENTS ARE MANDATORY FOR INSTALLATION IN A MOBILE HOME:
1) Stove must be permanently bolted to the floor. Remove the Base Trim and bolt thru the base flange.
2) Stove must have permanent outside air source. (69FAK)
3) Stove must be permanently electrically grounded to the steel chassis of the mobile home.
4) All vertical chimney vent must have wall supports.
5) All exhaust systems must have a spark arrestor.
THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL AND CEILING/
Check with your local building official as other codes may apply.
12
WARNING
DO NOT INSTALL IN SLEEPING ROOM
CAUTION
ROOF MUST BE MAINTAINED.
USSC