Table of Contents
Advertisement
CABINET DOOR KNOB ASSEMBLY
The cabinet door knob is mounted on the inside of
the cabinet door to facilitate shipping and must be
removed and re-installed for proper usage. To get
the cabinet door open, place your hand under the
cabinet frame (right hand side of the cabinet door)
and push door out.
FOLLOW THESE INSTRUCTIONS FOR DOOR KNOB
ASSEMBLY:
1. Remove the machine screw and the door knob.
2. Place the knob on the outside of the cabinet
door, re-install the machine screw and tighten
being careful not to strip out the threads in the
plastic handle.
CB36 ROOM BLOWER ASSEMBLY
NOTICE: The CB36 is standard equipment on the
model VG900B. If you wish to purchase an assembly,
you can contact your dealer for details or get it
directly from the U.S. Stove Company.
INSTALLATION
3. Remove the Panel (A) using tin snips or knock
out using a hammer and chisel careful not to
distort the mounting surface.
4. Attach the Blower Mounting Box (B) to the rear of
the unit using four(4) of the supplied #10 screws.
5. Then mount the Blower Assembly with the four(4)
remaining screws.
OPERATION
1. Rotating the rheostat control knob clockwise will
turn ON the blower.
2. When turned on, the blower comes on HIGH,
then as the knob is rotated clockwise, the blower
speed reduces.
3. Rotate the knob counter-clockwise to turn OFF.
Caution! Route the Power Supply Cord away from
the heat source and out of high traffic areas.
Assembly
MACHINE SCREW
CABINET DOOR KNOB
-13-
Advertisement
Table of Contents
