Dyna-Glo Delux RMC-FA150NGDGD Operating Instructions & Parts Manual page 2

Dyna-Glo Delux Operating Instructions and Parts Manual
Dyna-Glo
Construction Heater
Important Safety
Information (Continued)
WARNING General Hazard
Warn ing: Failure
to comply with the precautions and
instructions provided with this
heater can result in death, serious
bodily injury, and property loss, or
damage from hazards of fire,
explosion, burn, asphyx iation,
carbon monoxide poisoning, and/or
electrical shock. Only persons who
can under stand and follow these
instructions should use or service
this heater.
WARNING Fire, burn,
inhalation, and
explosion hazard. Keep solid
combustibles such as build ing
materials, paper, or cardboard, at
a safe distance away from heater
as recom mended by the
instructions. Never use the heater
in spaces which do or may contain
volatile or airborne combustibles or
products such as gasoline, solvents,
paint thinner, dust particles, or
unknown chemicals.
Not for home or
WARNING
recreational vehicle
use.
This heater has been designed as a
construction heater in accordance with
ANS Z83.7 CSA 2.14. Other standards
govern the use of fuel gases and
heating products for specific uses.
Your local authority can inform you of
these. The primary purpose of these
construction heaters are to provide
temporary heating of building under
construction, alteration, or repair. When
properly used, the heater provides
safe economical heating. Products of
combustion are vented into the heated
area.
- For either indoor or outdoor use.
Adequate ventilation must be
provided.
WARNING
This product and the fuels used to
operate this product (natural gas),
For Technical Support or Troubleshooting, Call: 1-877-447-4768, 8:30 am - 4:30 pm CST
Delux Natural Gas
®
and the products of combustion
of such fuels, can expose you to
chemicals including benzene, which
is known to the State of California
to cause cancer and reproductive
harm.
For more information go to
www.p65Warnings.ca.gov
DANGER
to death! Some people are more
affected by carbon monoxide than
others. Early signs of carbon monoxide
poisoning resemble the flu, with
headaches, dizziness, and/or nausea. If
you have these signs, the heater may
not be operating properly, or the
areas may not be sufficiently
ventilated. Get fresh air at once! Have
heater serviced.
Natural Gas: Natural gas has a
distinctive odor. This odor helps you
detect a natural gas leak. However,
the odor may fade. Natural gas may be
present even though no odor exists.
WARNING
Follow all local ordinances and codes.
In the absence of local ordinances and
codes, refer to the National Fuel Gas
Code handbook NFPA54/ANSI Z223.1
and the Natural Gas Installation Code,
CAN/CSA B149.1. This instructs on the
safe storage and handling of
flammable gases.
– Children should be carefully
supervised, when they are in the area.
– Always maintain proper clearance
from combustible materials. Minimum
clearance from combustibles:
Side - 24" (61 cm); Top - 48" (121.9
cm); Front - 72" (183 cm). Floor -
combustible. Not for use on finished
floors.
– Heater must be placed on level and
stable surface.
– Never place anything including
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
– The appliance area shall be kept clear
– Do not modify or operate a heater
Carbon monoxide
poisoning may lead
– Adequate clearance for accessibility
– Service and repair should be done by
– Never connect heater to an
Install and use
heater with care. – The heater is shipped from the
– The minimum and maximum inlet
2
RMC-FA150NGDGD
clothes or other flammable items on
the heater.
and free from combustible materials,
gasoline and other flammable
vapours and liquids.
which has been modified.
and for combustion & ventilation
air supply must be maintained at all
times when the heater is operating.
a qualified service person. The heater
should be inspected before each use
and at least annually by a qualified
person. More frequent cleaning may
be required as necessary. Do not
service while hot or operating.
unregulated gas supply.
factory for LP(Propane) gas. This
heater is for use with propane gas
only, do not convert heater to any
other gas. Installation must conform
to local codes or, in the absence of
local codes, with the standard for the
Storage and Handling of Liquefied
Petroleum Gases ANSI/NFPA 58
and the Natural Gas and Propane
Installation Code CSA B149.1
pressures to the regulator from the
gas tank are 5 psi and bottle pressure,
respectively. Use only the regulator
& hose assembly provided with the
heater. Inspect the regulator/hose
assembly prior to each use of the
heater. If there is excessive abrasion
or wear, or hose is cut, replace with
www.ghpgroupinc.com