Setup - Toro Pro Force 44547 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Note:
Determine the left and right sides of the
machine from the normal operating position.
Note:
To install and operate the debris blower, the
traction unit must be a 4 Wheel Drive machine which
is equipped with the Front Quick Attach Front Frame,
Model 30509 and one of the following; the Electric
Accessory Kit, part no. 115–0019 or the Joystick Kit,
model 31219.
Description
No parts required
Drive shaft assembly
Roll pin
Bolt, 5/16 x 1-3/4 inch
Locknut, 5/16 inch
Mounting plate
Bolt, 1/2 x 1-1/4 inches
Locknut, 1/2 inch
Debris blower assembly
Locking pin
Hairpin cotter
Proximity switch assembly
Sensor plate
Carriage bolt, 5/16 x 1-1/4 inch
Flange nut, 5/16 inch
General Purpose Lithium Base Grease
Qty.
–
Remove the blower from the crate.
1
1
Install the drive shaft to the blower gear
box shaft.
2
2
1
Install the mounting plate to the debris
4
blower frame.
4
1
1 Mount the blower to the traction unit.
1
1
1
Install the proximity switch
2
2
A/R Grease the machine
5
Use