Checking The Gear Box Lubrication; Checking The Nozzle - Toro Pro Force 44547 Operator's Manual

Drive shaft (Figure 22)
Checking the Gear Box
Lubrication
Service Interval: Every 50 hours
Gear box capacity: 207 ml (7 oz).
1. Position the machine and blower on a level
surface and lower the blower.
2. Remove the 5 bolts and washers securing the
gear case cover to the blower
1. Cover
2. Washer
3. Remove the cover to expose the blower gear
case (Figure 23).
Figure 22
(Figure 23).
Figure 23
3. Screw
4. Gear box
4. Remove the check/fill plug from the side of the
gear box
1. Check/fill plug
5. Check the oil level to make sure it is up to the
g021633
plug hole in the gear box. If the lubricant level
is low, add enough SAE 80-90 weight gear lube
to raise the level up to the hole.
6. Install the check/fill plug to the gear box.
7. Install the cover.

Checking the Nozzle

Service Interval: Before each use or daily
Checking the Nozzle Clamp
1. Check the nozzle clamp
ensure that is tight.
Note:
The nozzle can loosen if it is dragged
over obstacles or through low areas in the
terrain.
2. Tighten the clamp fasteners to maintain a gap
of 1.3 cm (0.50 inch).
The nozzle must rotate freely when moved by
hand.
g022000
1. Nozzle clamp
16
(Figure 24).
Figure 24
2. Drain plug
(Figure
Figure 25
2. 1.3 cm (.50 inch) gap
g022001
25) daily to
g023909