Table of Contents
Advertisement
Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Maintenance Safety
•
Before cleaning, servicing, or adjusting the
machine, do the following:
– Park the machine on a level surface.
– Wait for all moving parts to stop.
– Remove the machine from the traction unit.
– Lower the jack stand
– Allow machine components to cool before
performing maintenance.
•
Perform only those maintenance instructions
described in this manual. If major repairs are
ever needed or you need assistance, contact an
authorized Toro distributor.
•
Support the machine with blocks or jack stands
when working beneath it.
•
Ensure that all guards are installed securely after
maintaining or adjusting the machine.
•
Do not allow untrained personnel to service the
machine.
•
Keep all parts in good working condition and all
fasteners tightened. Replace all damaged or
missing decals.
•
Do not interfere with the intended function of a
safety device or reduce the protection provided
by a safety device. Check their proper operation
regularly.
•
If major repairs are ever necessary or assistance
is required, contact an authorized Toro distributor.
•
Altering this machine in any manner may affect the
operation of the machine, performance, durability,
or its use may result in injury or death. Such use
could void the product warranty of The Toro®
Company.
Lubrication
Service Interval: Every 50 hours
The debris blower has bearings and bushings that
must be lubricated regularly. If the machine is
operated under normal conditions, lubricate bearings
with No. 2 general purpose lithium base grease
after every 50 hours of operation. Lubricate fittings
immediately after every washing, regardless of the
interval listed.
The lubrication points are as follows:
Drive pulley
(Figure
Shown with cover removed
Castor wheel shaft (2)
15
20)
Figure 20
(Figure
21)
Figure 21
g021632
g011557
Advertisement
Table of Contents
