Table Of Contents; Indication To The Manual; Description Of Product - Brinkmann SFC1520 Series Operating Instructions Manual

BRINKMANN-Cutter pumps SFC1520...3000
Brinkmann Cutter pumps of the series SFC1520...3000
Contents
1 Indication to the manual .................................... 2
2 Description of product........................................ 2
3 Safety instructions ............................................. 4
4 Transport and storage ....................................... 5
5 Installation and Connection ............................... 5
6 Start up / Shut down .......................................... 7
7 Operation ........................................................... 7
8 Servicing and Maintenance ............................... 8

1 Indication to the manual

This operating manual gives basic instructions
which are to be observed during installation, op-
eration and maintenance of the pump. It is there-
fore imperative that this manual be read by the
responsible personnel and operator prior to as-
sembly and commissioning. It is always to be
kept available at the installation site.
Identification of safety instructions
1.1
in the operating manual
Safety instructions given in this manual non-com-
pliance with which would affect safety are identi-
fied by the following symbol:
Safety sign according with ISO
3864 - B.3.1
or where electrical safety is involved, with:
Safety sign according with ISO
3864 - B.3.6
The signal word WARNING indicates a hazard-
ous situation which, if not avoided, could result in
death or serious personal injury.
The signal word CAUTION indicates a hazardous
situation which, if not avoided, could result in mi-
nor or moderate personal injury.
The signal word ATTENTION indicates a hazard-
ous situation which, if not avoided, may cause a
risk to the machine and it's function.
BE3185
9 Trouble shooter's guide ..................................... 9
10 Spare part ........................................................ 10
11 Repair Instructions / Replacing shaft clamps
and shafts ........................................................ 12
12 Disposal ........................................................... 13
13 EC declaration of conformity ............................ 14

2 Description of product

General description of the pump
2.1
Pumps of the series SFC are one-stage rotary
pumps. The impellers are fixed on the driving
shaft extension. The pump shaft and motor shaft
are interconnected by means of a shaft clamp.
The cutting unit is cutting the chips and the semi-
open impeller with its large clearances allows to
pump the particles along with the coolant fluid
from the machine back to the filter. The SFC
pumps are capable of handling chip to coolant ra-
tios of up to 1.5% by weight.
Pump and motor form a compact and space-sav-
ing unit.
Vertically mounted pumps are equipped with a
mounting flange. The pump end immerses into
the tank and the motor extends vertically above
the tank.
Intended use
2.2
The cutter pumps of the series SFC are suited for
cutting aluminum chips or similar materials and
for pumping these materials along with the cool-
ant fluid.
- Pay attention of the limit of application in
table 1!
The cutter pumps are intended for installation in
machines and cannot be operated alone.
11/2019
Edition
2