TP-Link TL-WR820N User Manual page 36

Chapter 4
How can I do that?
1 Change the routers' LAN IP addresses to two different IP addresses on the same
subnet. Disable Router B's DHCP function.
2 Visit http://tplinkwifi.net, and log in with the password you set for Router A.
3 Go to Advanced
4 Click Add and finish the settings according to the following explanations:
• Network Destination
static route. This IP address cannot be on the same subnet with the WAN IP or
LAN IP of Router A. In the example, the IP address of the company network is
the destination IP address, so here enter 172.30.30.1.
• Subnet Mask
the network portion, and which portion is the host portion.
• Default Gateway
packets will be sent. This IP address must be on the same subnet with the
Router A
LAN: 192.168.0.1
192.168.0.100
> Network > Routing
- The destination IP address that you want to assign to a
- The Subnet Mask determines which portion of an IP address is
- The IP address of the gateway device to which the data
Configure the Router in Wireless Router Mode
Router B
WAN: 172.30.30.100
LAN: 192.168.0.2
Switch
PC
and locate the Static Routing
Company's server
172.30.30.1
section.
31