Step 2 Attach Cylinder Shroud To Legs; Step 4 Attach Cap Assembly To Legs/Insert Gas Line - Blue Rhino Endless Summer 153100 Owner's Manual

7
Contact 1-800-762-1142 for assistance.
®
Do not return to place of purchase.
Step 2–Attach Cylinder Shroud to Legs
Line up slots in Cylinder Shroud flange with notches in left leg as shown.
Line up holes in center of Shroud with holes in Center Leg. Attach
Cylinder Shroud to center Leg using (2) Medium Screws.
Secure Cylinder Shroud to outside Legs using (2) Medium
Screws per leg.
Tighten nuts and bolts from Step 1.
TIP:
To tighten use a 7/16" wrench on Bolt and a 7/16" socket wrench on Nut.
Step 3–Attach Weight Plate to Base
Place Spacer Ring on Support Plate so that all holes in plate fit
inside ring.
Line up 3 small, unthreaded holes in plate with corresponding holes
in cap.
Line up these holes with three threaded holes in Cup.
Insert (1) Large Bolt and tighten loosely.
Repeat for other (2) Large Bolts, then secure all tightly.
Step 4 – Attach Cap Assembly to Legs/Insert Gas Line
Line up 3 holes in Cap Assembly with holes in top of Shroud and legs.
Insert and tighten (1) Medium Screw into center leg.
Insert and tighten (1) Medium Screw into each of the outer legs.
Tilt base on edge and slide Gas Line up through large hole in Base, then
through Cap Assembly.
Owner's manual: model 153100 outdoor patio heater 2/13/04