Step 2 Attach Cylinder Shroud To Legs; Step 3 Assemble Cup, Plate & Ring To Cap; Step 4 Attach Cap Assembly To Legs/Insert Gas Line - Blue Rhino Endless Summer 163010 Owner's Manual

7
Contact 1-800-762-1142 for assistance.
Step 2 – Attach Cylinder Shroud to Legs
TIP:
To tighten use a 7/16" wrench on Bolt and a 7/16" socket wrench on Nut.
Step 3 – Assemble Cup, Plate & Ring to Cap
Step 4 – Attach Cap Assembly to Legs/Insert Gas Line
Owner's manual and assembly instructions: model 163010 natural gas outdoor patio heater
Do not return to place of purchase.
• Line up slots in Cylinder Shroud flange with notches in left leg as
shown.
• Line up holes in center of Shroud with holes in Center Leg. Attach
Cylinder Shroud to center Leg using (2) Medium Screws.
• Secure Cylinder Shroud to outside Legs using (2) Medium Screws
per leg.
• Tighten nuts and bolts from Step 1.
• Place Spacer Ring on Support Plate so that all holes in plate fit
inside ring.
• Line up 3 small, unthreaded holes in plate with corresponding holes
in cap.
• Line up these holes with three threaded holes in Cup.
• Insert (1) Large Bolt and tighten loosely.
• Repeat for other (2) Large Bolts, then secure all tightly.
• Line up 3 holes in Cap Assembly with holes in top of Shroud
and legs.
• Insert and tighten (1) Medium Screw into center leg.
• Insert and tighten (1) Medium Screw into each of the outer legs.
Tilt base on edge and slide Gas Line up through large hole in Base,
then through Cap Assembly.
12/4/02