Fujitsu PRIMERGY TX600 S3 Service Supplement Manual page 43

Replacement routines
C
Figure 26: Removing the system board
Ê Unplug all cables from the system board.
Ê Remove the system board as follows:
– Lift the blue button in the middle of the system board (A).
– Holding the button lifted up, slide the system board toward the front of the
housing (B) to be able to lift them out of the fastening elements (C).
– Now lift the system board out of the housing (D), pushing the ventilation
foil attached to the side out of the way.
To install the power backplane perform the above procedure in reverse.
I
To ensure correct operation, make sure you do the following after
installing the new system board:
– Updating the BIOS firmware
– Setting the BIOS default values
– Adjusting the customer-specific settings
This completes the replacement of the system board.
D
A
B
Service Supplement TX600 S3
Replacing the system board
43