Uniden TRU 8885 Series Owner's Manual page 32

[ 3 1 ] G E T T I N G S T A R T E D
Setting the Dial Mode
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing;
the default setting is tone dialing. Set the dialing mode to match the dialing
system used by your local phone service.
• If you are not sure of your dialing system, set the unit to tone dialing. Make a trial call. If
the call connects, leave the setting as is; otherwise set the unit to pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones in certain
situations during a call, you may switch over to tone dialing (refer to "Tone Dialing
Switch-over" on page 39).
1) Enter the Global Setup menu, and then the Dial Mode
submenu (see "Entering the Menu" on page 16).
2) Press volume up/down to select
initial setting is Tone).
3) Press the OK soft key. You will hear a confirmation tone.
or (the
T o ne Pu l se
w w w . u n i d e n . c o m